How to Keep Up with Weed Eater Maintenance in Ogden, UT

August 20, 2019

Your weed eater is likely one of your favorite landscaping tools. Take care of your trimmer, and it’ll work well and last for a long time. Here’s what you should do if you want to perform weed eater maintenance in Ogden, UT the right way.

Take safety precautions

First things first, make sure your weed trimmer is turned off. Check that the power button is OFF and that the gas tank is empty. Then, make sure the spark plug wire is disconnected. These points and others should be taken into consideration to avoid injury or damage to the equipment:

  • Use rubber tools: Weed eaters are electric devices, so you want to avoid using maintenance tools without rubber handles. Rubber is the best material for resisting electric shocks, which is why it’s highly recommended you use rubber-handled tools from the start of your maintenance process all the way to the end.
  • Power it off: Doing weed trimmer maintenance with the power on can be bad for you—in fact, it can be a life-threatening situation. For safety’s sake, make sure the power is turned off.
  • Empty out the gas tank: Whether performing maintenance or putting it away for the season, be sure to empty the fuel tank. You don’t want to store gas-filled equipment in a closed shed all winter or get gas on your skin or clothes while cleaning.

Clean it

Since cleaning is an important part of lawn equipment maintenance, take the time to clean your weed eater at least once a year. Give the exterior parts a good scrubbing using a thick, durable brush and a mix of water and dish soap. This mixture will remove any dirt, grease and debris that’s accumulated on the surface over the summer.

Replace old string

The string on some weed eaters may need to be replaced more often than others, especially regularly-used devices. But it’s just a string, right? In fact, as simple as this string looks, it’s actually fairly complex in how it works, which means that replacing the string is a crucial maintenance step. A new string ensures the weed eater is effective, efficient and fast when you need it to be, and that it won’t rip apart in the middle of a job. The most essential steps in replacing the string are as follows:

  • Remove the disk.
  • Remove and dispose of any string left behind.
  • Install a new string in the weed trimmer mechanism.
  • Every 90 days, replace the filter based on its condition.

Remove the spark plug

You should empty the gas tank and remove the spark plug every three to four months, depending on use. Spark plugs change color as they dirty and age—a brown spark plug needs more engine oil, while a black one needs to be replaced.

Empty the gas tank

When you’re done with your trimmer for the season, empty remaining gas from the tank. This reduces the chances of oil particles settling and causing problems for your device. Dispose of gas properly and tighten loose nuts and screws.

Need help with your trimmer? Call Ogden Lawn & Garden to schedule weed eater maintenance in Ogden, UT!

Categorised in:

Ogden Lawn & Garden